SpinBlast HD Tool, w/electric motor and carriage

Description

Ideal for I.D. pipe Greater than 14".

The Clemtex SB-636-B Heavy Duty Spinblast Tool is designed to abrasive blast clean the internal diameter of pipe. This unit includes a pneumatic driven motor to rotate the blast head, and an adjustable carriage designed to center the tool in the pipe to produce a uniform blast cleaned surface.

Production Rate

This tool is shipped with two (2) 1-1/4" threaded venturi blast nozzles. This unit with operate with nozzle sizes 1/4" to 5/8" I.D. The production rate varies depending on the degree of cleanliness required, surface condition, type of abrasive, nozzle size and blasting pressure. Contact a Clemtex Representative to determine an estimated production rate for your specific application.

Travel Rate

The speed (feet per minute) that this tool is pulled through a pipe depends on the diameter of pipe, degree of cleanliness required, surface condition, abrasive size, nozzle size and blasting pressure. A platform or structural support for the wheels of the Spinblast tool to drive on must be provided at the exit/entrance of the pipe to support the weight of the tool. Do not manually lift the tool out of the exit point of the pipe while blasting.

Blast Head Rotating Speed

A variable speed electric motor turns the blast head of the tool. The motor should be adjusted to 40-60 RPM to produce an even blasted surface. For very large diameter pipe, a slower rotational speed is desired for the best performance. For this reason, the electric motor is preferred in large-diameter blasting situations.

Blast Hose Connection

The blast hose connection on the tool is 2" NPS-M. A standard 2" threaded blast hose fitting (CFB00555) is required if the Spinblast tool in not attached to a pipe lance. The blast hose or pipe lance feeding the tool must be a minimum of 1-1/4" I.D. Smaller diameter hose or pipe lances could lead to premature wear on the Spinblast tool.